NEW Pneumatic Crimper Air Powered Wire Terminal Crimping Machine Tool 1.8T USA. A new small pneumatic crimping machine, instead of manual crimping tools, has a speed of 10 times that of manual crimping tools, and saves air source more than ordinary pneumatic tools. It can change the jaw according to different terminals, which is fast and firm after crimping. Crimping range: insulation end 0.5 10 mm 2.Pressure range: 0.5-0.7kpa. Please connect the air pipe according to the corresponding label of the equipment and its accessories. At this time, the tong head of the equipment should be in the open state, and then crimp.
After the fixture is installed, slowly step on the foot valve to make the machine run at low speed to check the installation effect of the fixture. Put the end to be crimped in the position of the corresponding fixture, step on the foot valve. After the crimping is completed, release the air valve. The crimping speed can be manually controlled according to the speed of the stepping valve, or the pipe joint with throttle valve can be selected for adjustment.Mini practical, easy to carry. The operation is faster and more convenient. 3High quality alloy steel, longer service life, no need to replace die band. 1 xPneumatic Terminal Crimping Machine. This equipment uses the fluid: compressed air. Service environment and fluid temperature 5-60? For the pipes connected to the equipment, the corresponding air pipes and joints should be selected, and the internal makeup must be cleaned to prevent the foreign matters from entering the cylinder and damaging the cylinder. When crimping large square ends, please ensure sufficient air supply and air pressure. If it is used in low temperature environment, anti freezing measures should be taken to prevent water freezing in the system. Please allow 1-3MM differs due to manual measurement.
Due to the different display and different light, the picture may not reflect the actual color of the item. Feedback is very important to us. It is impossible to address issues if we do not know about them!Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. Insulation end 0.5 10 mm 2.