Common Rail Diesel Fuel Injector Pneumatic Puller Hammer Remover Tool Puller Kit

Select the correct connector according to the injector, put the pneumatic pullerthrough between the connector and the injector and tighten it. The torque of thewrench is between 20-30nm. Looseness will cause damage to the thread during the impact drawing process. Use high-pressure gas, the air pressure is generally between 5-8bar, payattention to the gas as it needs to be clean and not contain any moisture, otherwise the internal cylinder of the puller will be stuck or corroded bymoisture.

Use the air pressure flow switch to control the pulling frequency of the pullerand observe whether the injector is pulled out. When it is about to be pulled out, turn off or reduce the air pressure to prevent the injector head from hitting theengine water jacket. After use, the tool should be stored in a cool, dry environment. Avoid storage in a humid place and regularly inject about 1mL ofoil into the air inlet of the puller every 10 hours of work to prevent the internalpiston cylinder from being wet and causing rust stains. The color of the box and accessories will be randomly sent, please refer to the actual received product for accuracy.

Note:Doesn't encourage their use for illegal purposes.

---